Test Description
The number below refers to the step number on the diagnostic table.
- 3: Tests the pump motor circuits of the BPMV for a short to the housing of the BPMV. The wiring from the BPMV to the EBCM should not be repaired.
DTC C0110
| Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
| Schematic Reference: ABS Schematics Connector End View Reference: ABS Connector End Views |
||||
| 1 | Did you perform the Diagnostic System Check - Vehicle? | - | Go to Step 2 | Go to Diagnostic System Check - Vehicle in Vehicle DTC Information |
| 2 |
|
- | Go to Step 8 | Go to Step 3 |
| 3 |
|
5 Ω | Go to Step 4 | Go to Step 5 |
| 4 | Inspect for poor connections at the pump motor harness pigtail connector of the BPMV. Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
in Wiring Systems. Did you find and correct the condition? |
- | Go to Step 8 | Go to Step 6 |
| 5 | Inspect for poor connections at the harness connector of the EBCM. Refer to Testing for Intermittent Conditions and Poor Connections
, Connector Repairs
and Wiring Systems. Did you find and correct the condition? |
- | Go to Step 8 | Go to Step 7 |
| 6 | Replace the BPMV. Refer to Control Module References
in Computer/Integrating Systems for replacement, setup, and programming. Did you complete the repair? |
- | Go to Step 8 | - |
| 7 | Replace the EBCM. Refer to Control Module References
in Computer/Integrating Systems for replacement, setup, and programming. Did you complete the repair? |
- | Go to Step 8 | - |
| 8 |
|
- | Go to Step 2 | System OK |