LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2005 >> Aztek Base, AWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - 3.4L - Introduction >> Repair Instructions >> Accelerator Controls Cable Bracket Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    Fig 1: View Of Accelerator Bracket & Cable
    GM260171Courtesy of GENERAL MOTORS CORP.
  1. Position the accelerator cable bracket on the throttle body.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the nut (3) and bolts (1, 2).

    Tighten: 

    • Tighten the bolts in sequence (2, 1) to 13 N.m (115 lb in).
    • Tighten the nut in sequence (3) to 10 N.m (89 lb in).

    3. Fig 2: Locating Accelerator Controls Cable
    GM12831Courtesy of GENERAL MOTORS CORP.
  3. Connect the cruise control cable into accelerator cable bracket.
  4. Connect the accelerator cable to the throttle body lever.
  5. Connect the cruise control cable to the throttle lever and accelerator bracket, if applicable.
scientia non olet · About LEMON Manuals