Installation Procedure
WARNING: This page is about a different car, the 2004 Chevrolet Monte Carlo and 2004 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
- Record the 11-digit electronic serial number (ESN) and the 10-digit station identification (STID) number from the label on the new VCIM.
- Position the communication interface module to the bracket (2).
- Install the communication interface module bolts (1).
Tighten: Tighten the bolts to 10 N.m (89 lb in).
- Connect the GPS antenna cable to the module.
- Connect the electrical connectors to the module.
- Connect the cellular antenna cable to the module.
- Reconfigure the OnStar® system. Refer to OnStar Reconfiguration .
- Position the assembly to the studs.
- Install the bracket nuts to the communication interface module.
Tighten: Tighten the nuts to 4 N.m (35 lb in).
- Install the communication interface module cover.
- Close the rear compartment.
NOTE:
Refer to Fastener Notice
in Cautions and Notices.
IMPORTANT:
After replacing the communication interface module, you must reconfigure the OnStar® system. Failure to reconfigure the system will result in an additional customer visit for repair.