Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.

Align the BCM to the I/P trim pad.

Fig 1: View Of BCM

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the BCM screws.
Tighten: Tighten the screws to 2 N.m (18 lb in).

Fig 2: View Of BCM Screws

Courtesy of GENERAL MOTORS CORP.

Connect the lower BCM electrical connectors. Engage the cam lock.

Fig 3: View Of BCM Electronic Connectors

Courtesy of GENERAL MOTORS CORP.

Align the I/P steering column opening filler to the I/P trim pad. Press the filler panel to the I/P trim pad.
Install the I/P steering column opening filler screws.
Tighten: Tighten the screws to 2 N.m (18 lb in).

Fig 4: View Of I/P Steering Column Opening Filler

Courtesy of GENERAL MOTORS CORP.

Install the I/P accessory trim plate. Refer to Trim Plate Replacement - Instrument Panel (I/P) Accessory in Instrument Panel, Gages, and Console.

Fig 5: View Of I/P Accessory Trim Plate

Courtesy of GENERAL MOTORS CORP.

Install the ignition switch bezel.
Align the DLC to the I/P trim pad. Install the DLC to the I/P trim pad.

Fig 6: View Of DLC

Courtesy of GENERAL MOTORS CORP.

Install the lamp to the left I/P insulator opening.
Align the left I/P insulator to the I/P trim pad.
Install the I/P insulator fasteners.

Fig 7: View Of I/P Insulator

Courtesy of GENERAL MOTORS CORP.

Connect the upper electrical connector to the BCM. Engage the cam lock.
Align the left I/P compartment access hole cover to the I/P trim pad. Press the I/P compartment access hole cover to the I/P trim pad.

Fig 8: View Of Left Instrument Panel Outer Trim Cover

Courtesy of GENERAL MOTORS CORP.

Perform the new BCM setup. Refer to Body Control Module (BCM) Programming/RPO Configuration .