LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2005 >> Aztek Base, AWD >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transaxle - Introduction & Repair Instructions >> Repair Instructions >> Shift Indicator Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    Fig 1: Identifying Shift Indicator Fasteners
    GM908764Courtesy of GENERAL MOTORS CORP.
  1. Carefully install the shift indicator.
    2. Fig 2: View Of Alignment Pin And Alignment Tab
    GM908768Courtesy of GENERAL MOTORS CORP.
  2. Ensure that the alignment pin and alignment tab are properly engaged.
    3. Fig 3: Centering Shift Lever In Shift Indicator
    GM908777Courtesy of GENERAL MOTORS CORP.
  3. Ensure that the shift lever is centered in the shift indicator.
    4. Fig 4: Identifying Shift Indicator Fasteners
    GM908750Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the shift indicator fasteners.

    Tighten:  Tighten the shift indicator fasteners in the order shown to 2 N.m (18 lb in).

  5. Move the shift control through the entire range. If the shift lever contacts either side of the shift indicator, loosen the shift indicator fasteners and repeat the installation procedure.
  6. Connect the shift indicator lamp to the shift indicator and ensure that the shift indicator lamp is functional.
  7. Install the center console trim plate. Refer to Trim Plate Replacement - Front Floor Console (Aztek) or Trim Plate Replacement - Front Floor Console (Rendezvous) in Instrument Panel, Gages and Console.
    8. Fig 5: Locating Shift Control Handle Retainer
    GM980182Courtesy of GENERAL MOTORS CORP.
  8. Install the shift control handle.
  9. Install the shift control handle retainer.
  10. Shift the transaxle into Park.
  11. Disengage the park brake and remove the wheel blocks.
scientia non olet · About LEMON Manuals