LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2005 >> Aztek Base, FWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - 3.4L - Introduction >> Repair Instructions >> Air Cleaner Intake Duct Replacement >> Removal Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal Procedure

    Fig 1: Locating Intake Air Duct Clamps From MAF Sensor & Throttle Body
    GM763014Courtesy of GENERAL MOTORS CORP.
  1. Loosen the 2 intake air duct clamps (1) from the mass airflow (MAF) sensor (2) and the throttle body.
  2. Remove the intake air temperature (IAT) sensor from the duct. Refer to Intake Air Temperature (IAT) Sensor Replacement .
  3. Disconnect the vent tube from the air intake duct.
  4. Disconnect the MAF sensor electrical connector.
    5. Fig 2: Identifying Air Cleaner Cover Clips
    GM763010Courtesy of GENERAL MOTORS CORP.
  5. Unlatch the air cleaner cover clips (1) and remove the air intake duct and air cleaner cover.
  6. Separate the air intake duct from the MAF sensor.
scientia non olet · About LEMON Manuals