Removal Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Electrical Connector & CPA

Courtesy of GENERAL MOTORS CORP.

Remove the instrument panel (I/P) insulator. Refer to Knee Bolster, Insulator, Molding Replacement - Instrument Panel in Instrument Panel, Gages and Console.
Disengage but do not remove the connector position assurance (CPA) on the connector.
Disconnect the electrical connector (2).

Fig 2: Identifying Brake Pedal Position Sensor Screw

Courtesy of GENERAL MOTORS CORP.

Remove the screw.
Remove the brake pedal position sensor.