Installation Procedure

WARNING: This page is about a different car, the 2005 Saturn L300. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing/Installing Accelerator Pedal Position Sensor

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Position the APP sensor in the bracket and install the bolts.
Tighten: Tighten the accelerator pedal position sensor bolts to 6 N.m (53 lb in).

Fig 2: Disconnecting Linkage From Accelerator Pedal Position Sensor

Courtesy of GENERAL MOTORS CORP.

Connect the APP sensor to the accelerator pedal linkage.

Fig 3: Removing/Installing Accelerator Pedal Assembly

Courtesy of GENERAL MOTORS CORP.

IMPORTANT: Do not tighten fasteners at this time.

Position the APP assembly in the vehicle and install the lower pedal to the front of the dash attachment nuts.
Depress the accelerator pedal and install the upper pedal bracket to the front of the dash attachment nut.
Tighten all 3 nuts.
Tighten: Tighten the accelerator pedal bracket-to-front of the dash nuts to 10 N.m (89 lb in).
Connect the APP sensor harness connector. Push the connector in until the lock position is felt, then pull back to confirm engagement.

Fig 4: Removing/Installing Left Side Lower Instrument Panel Closeout Panel

Courtesy of GENERAL MOTORS CORP.

Install the left side lower heater duct and attachment fasteners.
Install the left side lower I/P closeout panel (hush panel) and attachment fasteners.