LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2005 >> GTO Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 10 (Engine Controls - Introduction) >> Repair Instructions >> Manifold Absolute Pressure (MAP) Sensor Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2005 Saturn L300. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Manifold Absolute Pressure Sensor
    GM894678Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Make sure the MAP sensor mounting surface is clean. Install the MAP sensor with the grommet and attachment bolt.

    Tighten:  Tighten the manifold absolute pressure sensor bolt to 5 N.m (44 lb in).

  2. Connect the MAP sensor harness connector. Push the connector in until the lock position is felt, then pull back to confirm engagement.
scientia non olet · About LEMON Manuals