LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2005 >> Grand Prix Base >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - 3.8L - Introduction >> Repair Instructions >> Crankshaft Position (CKP) Sensor Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    Fig 1: Removing/Installing CKP Sensor
    GM12303Courtesy of GENERAL MOTORS CORP.
  1. Install the CKP sensor.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the CKP sensor studs.

    Tighten:  Tighten the studs to 30 N.m (22 lb ft).

    3. Fig 2: Removing/Installing CKP Sensor Shield
    GM12302Courtesy of GENERAL MOTORS CORP.
  3. Install the CKP sensor shield (1).
  4. Connect the CKP sensor electrical connector.
  5. Install the crankshaft harmonic balancer. Refer to Crankshaft Balancer Replacement in Engine Mechanical - 3.8L.
  6. Lower the vehicle.
  7. Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure (RPOs L26/L32) or Battery Negative Cable Disconnect/Connect Procedure (RPO LS4) in Engine Electrical.
  8. Perform the crankshaft position system variation learn procedure. Refer to CKP System Variation Learn Procedure .
scientia non olet · About LEMON Manuals