LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2005 >> Grand Prix GT >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - 3.8L - Introduction >> Repair Instructions >> Knock Sensor (KS) 2 Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

NOTE: Refer to Fastener Notice in Cautions and Notices.
IMPORTANT: DO NOT apply thread sealant to sensor threads. The sensor is coated at factory and applying additional sealant will affect the sensors ability to detect detonation.
    Fig 1: Locating Knock Sensor 2 Components
    GM381311Courtesy of GENERAL MOTORS CORP.
  1. Install the knock sensor (4).

    Tighten:  Tighten the knock sensor to 19 N.m (14 lb ft).

  2. Install the knock sensor heat shield.

    Tighten:  Tighten the bolts to 60 N.m (44 lb ft).

  3. Connect the knock sensor electrical connector.
  4. Install Transaxle refer to TRANSMISSION REPLACEMENT .
  5. Fill the cooling system. Refer to Draining and Filling Cooling System (L26 and L32) or Draining and Filling Cooling System (LS4) in Engine Cooling.
scientia non olet · About LEMON Manuals