Installation Procedure
- Route the accelerator control cable (2) through the control cable bracket (1).
- Press the cable tabs (2) into the bracket (1).
Ensure the tangs expand and properly seat.
- Install the control cable lug (3) to the throttle body cam.
- Connect the cable (2) to the support clip (1).
- Install the cruise control cable (2), if applicable.
- Install the cable (1) to the pedal lever assembly. Ensure the tangs are fully expanded and seated.
- Slip the accelerator cable through the slot in the rod of the accelerator pedal and install the retainer in the rod. Ensure the retainer is seated.
- Ensure the cable is completely seated in the throttle cam past the retaining clips.
- Inspect for the correct opening and closing positions by operating the accelerator pedal. Make sure that the throttle valve reaches wide-open throttle position. If not, inspect for damaged or a bent bracket or lever
IMPORTANT:
Flexible components, i.e. hoses, wires, conduits, etc., must not be routed within 50 mm (2.0 in) of the moving parts of the accelerator linkage outboard support unless the routing is positively controlled.