LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2005 >> Sunfire Automatic >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - 2.2L - Introduction >> Repair Instructions >> Crankshaft Position (CKP) Sensor Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

  1. Inspect the CKP sensor O-ring and lubricate with a mineral based grease.
    2. Fig 1: View Of Crankshaft Position (CKP) Sensor
    GM770823Courtesy of GENERAL MOTORS CORP.
  2. Gently insert the CKP sensor into the block.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the CKP sensor bolt.

    Tighten:  Tighten the CKP sensor bolt to 8 N.m (71 lb in).

  4. Reconnect the CKP sensor electrical connector.
  5. Reinstall the starter. Refer to Starter Motor Replacement in Engine Electrical.
  6. Reinstall the front air deflector, if removed in previous step.
  7. Lower the vehicle.
  8. Reconnect the battery. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.
  9. Perform the CKP system Variation Learn Procedure. Refer to CKP System Variation Learn Procedure .
scientia non olet · About LEMON Manuals