LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2005 >> Sunfire Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - 2.2L - Introduction >> Repair Instructions >> Accelerator Controls Pedal Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    Fig 1: Identifying Accelerator Control Cable
    GM14159Courtesy of GENERAL MOTORS CORP.
  1. Install the pedal assembly (2) to the cowl.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the retaining nuts.

    Tighten:  Tighten the nuts to 30 N.m (22 lb ft).

  3. Slip the accelerator cable (1) through the slot in the rod and then install the retainer in the rod, being sure that the retainer is seated.
  4. Install the left sound insulator.
  5. Inspect for correct opening and closing positions by operating the accelerator pedal. Make sure that the throttle valve reaches a wide open throttle (WOT) position. If not, inspect for a damaged or bent bracket, lever, or other component, or for carpet under the accelerator pedal.
scientia non olet · About LEMON Manuals