Removal Procedure

Remove the floor shift control. Refer to Floor Shift Control Replacement in Automatic Transmission - 4L60-E/4L65-E.
Using the manual override lever, shift the selector lever to the drive (D) position.

Fig 1: Locating Selector Knob Retaining Screw

Courtesy of GENERAL MOTORS CORP.

Remove the selector knob retaining screw (1), then remove the selector knob.

Fig 2: View Of Selector Assembly Wiring Harness Connector

Courtesy of GENERAL MOTORS CORP.

Disconnect the wiring harness connector (1) from the rear of the selector assembly.

Fig 3: View Of Selector Lever Housing, Base & Insulator

Courtesy of GENERAL MOTORS CORP.

Disconnect the selector lever housing (1) from the base (2) by depressing the four retaining tabs.
Lift the shift lever housing assembly from the base.
Remove the insulator (3) from the base.

Fig 4: View Of Solenoid Wiring Harness Connector & Retaining Screws

Courtesy of GENERAL MOTORS CORP.

Disconnect the solenoid wiring harness connector (1) from the shift lock solenoid.
Remove the solenoid retaining screws (4).
Remove the solenoid.

Fig 5: Locating Park Lock Micro Switch Retaining Screws

Courtesy of GENERAL MOTORS CORP.

If necessary, remove the park lock micro switch retaining screws (1,2).

IMPORTANT: Note the position of the micro switch wiring harness routing for reassembly. The switches are incorporated into the wiring harness and cannot be serviced separately.

Remove the micro switches and wiring harness from the floor shift control base plate.