LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2007 >> Grand Prix Base >> Repair and Diagnosis >> Brakes >> Anti-Lock Brake System, Traction Control System & Stability Control System >> Repair Instructions >> Electronic Brake Control Module Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    Fig 1: View Of EBCM To BPMV Screws
    GM213438Courtesy of GENERAL MOTORS CORP.
  1. Connect the pump motor connector (3) to the bottom of the EBCM.
  2. Install the EBCM (1) to the BPMV (4).
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the 6 EBCM to BPMV retaining bolt/screws (2).

    Tighten:  Tighten the retaining bolt/screws to 2.9 N.m (26 lb in).

    4. Fig 2: Identifying EBCM Harness Connector
    GM230405Courtesy of GENERAL MOTORS CORP.
  4. Connect the EBCM harness connector.
  5. Reengage the locking tab (1) to the EBCM harness connector.
  6. Install the air cleaner intake duct. Refer to Air Cleaner Inlet Duct Replacement in Engine Controls - 3.8L.
  7. Reposition the module and cables. Connect the cruise control module to the left strut tower.
  8. Connect the accelerator and cruise control cable to the accelerator control cable bracket.
  9. Install the front fender upper diagonal brace. Refer to Front Fender Upper Diagonal Brace Replacement in Body Front End.
  10. Install the fuel injector sight shield, 3.8L engine only. Refer to Fuel Injector Sight Shield Replacement (L26) or Fuel Injector Sight Shield Replacement (L32) in Engine Mechanical - 3.8L.
  11. Turn the ignition switch to the RUN position. Do not start the engine.
  12. Perform the Diagnostic Starting Point - Antilock Brake System .
  13. Refer to Control Module References for programming and setup information.
scientia non olet · About LEMON Manuals