LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2007 >> Torrent FWD >> Repair and Diagnosis >> Steering >> Power Steering System >> Repair Instructions >> Power Steering Gear Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

  1. If applicable, install the heat shield.
    2. IMPORTANT: Ensure the stabilizer is swung in the upper-most position for gear clearance.
  2. Install the steering gear from the right side of the vehicle.
    3. Fig 1: View Of Steering Gear & Steering Gear-To-Frame Bolts
    GM927957Courtesy of GENERAL MOTORS CORP.
  3. Center the gear mounting bushings into the cradle supports.
    4. NOTE: Refer to Fastener Notice .
  4. Hand start both steering gear to cradle mounting bolts.

    Tighten:  Tighten the bolts to 110 N.m (81 lb ft).

    5. Fig 2: View Of Steering Shaft To Intermediate Shaft
    GM927947Courtesy of GENERAL MOTORS CORP.
  5. Connect the intermediate shaft to the steering gear and install a new pinch bolt.

    Tighten:  Tighten the intermediate pinch bolt to 34 N.m (25 lb ft).

    6. Fig 3: View Of Stabilizer Shaft & Link
    GM927949Courtesy of GENERAL MOTORS CORP.
  6. Connect the stabilizer links to the stabilizer bar. Refer to Stabilizer Shaft Link Replacement .
    7. Fig 4: View Of Tie Rod End To Steering Knuckle
    GM854972Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Hold the ball stud to prevent turning during installation of the nut.
  7. Connect the tie rod to the knuckle and install a new nut.

    Tighten:  Tighten the nut to 25 N.m (18 lb ft) plus 90 degrees.

  8. Install the front tires and wheels. Refer to Tire and Wheel Removal and Installation .
  9. Check the front wheel alignment and align as necessary. Refer to Measuring Wheel Alignment .
  10. Lower the vehicle.
scientia non olet · About LEMON Manuals