LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2008 >> Solstice Base, Automatic >> Repair and Diagnosis >> Brakes >> Anti-Lock Brake System, Traction Control System & Stability Control System >> Diagnostic Information & Procedures >> DTC C0460 >> Circuit/System Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Circuit/System Testing

  1. Ignition OFF, disconnect the harness connector at the steering angle sensor.
  2. Test for less than 6 ohm of resistance between the low reference circuit terminal 6 and ground.
    • If greater than the specified range, test for an open/high resistance in the low reference circuit. If the circuit tests normal, replace the EBCM.
  3. Ignition ON, test for 11.8-12.2 volts between the 12-volt reference circuit terminal 1 and ground.
    • If less than the specified range, test the 12-volt reference circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the EBCM.
    • If greater than the specified range, test the 12-volt reference circuit for a short to voltage. If the circuit tests normal, replace the EBCM.
  4. Ignition OFF, disconnect the harness connector at the EBCM.
  5. Ignition ON, test for 0 volts between the communication circuit terminal 18 and ground.
    • If greater than the specified value, test the communication circuit for a short to voltage.
  6. Test for 0 volts between the communication circuit terminal 19 and ground.
    • If greater than the specified value, test the communication circuit for a short to voltage.
  7. Ignition OFF, test for infinite resistance between the communication circuit terminal 18 and ground.
    • If not the specified value, test the communication circuit for a short to ground.
  8. Test for infinite resistance between the communication circuit terminal 19 and ground.
    • If not the specified value, test the communication circuit for a short to ground.
  9. Test for less than 1 ohm of resistance between the communication circuit terminals 18 and terminal 3.
    • If greater than the specified range, test the communication circuit for an open/high resistance.
  10. Test for less than 1 ohm of resistance between the communication circuit terminals 19 and terminal 4.
    • If greater than the specified range, test the communication circuit for an open/high resistance.
  11. Test for infinite resistance between the communication circuit 18 and the communication circuit 19.
    • If not the specified value, test the communication circuits for a short together.
  12. If all circuits test normal, replace the Steering Angle Sensor.
scientia non olet · About LEMON Manuals