LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2009 >> Torrent Base, AWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls And Fuel - 3.4L - Introduction >> Repair Instructions >> Fuel Hose/Pipes Replacement - Chassis >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    Fig 1: View Of Fuel Hose/Pipe & Retainers At Vehicle Underbody
    GM49888Courtesy of GENERAL MOTORS CORP.
  1. Install the fuel hose/pipe to the vehicle.
  2. Install the fuel hose/pipe from the pipe retainers.
  3. Attach the pipe retainers (1) to the vehicle underbody.
  4. Remove the caps from the fuel pipes.
    5. Fig 2: View Of Chassis Fuel Supply Line, EVAP Canister Purge Hose/Pipe & EVAP Canister-To-Underbody Nuts
    GM1371133Courtesy of GENERAL MOTORS CORP.
  5. Connect the chassis fuel hose/pipe (2) to the fuel tank. Refer to Metal Collar Quick Connect Fitting Service .
  6. Lower the vehicle from the hoist.
  7. Remove the caps from the fuel pipes.
    8. Fig 3: Disconnecting/Connecting Engine Fuel Hose/Pipe At Chassis Fuel Hose/Pipe
    GM1371132Courtesy of GENERAL MOTORS CORP.
  8. Connect the engine compartment fuel hose/pipe (2) to the chassis fuel hose/pipe (3). Refer to Metal Collar Quick Connect Fitting Service .
  9. Connect the negative battery terminal. Refer to Battery Negative Cable Disconnection and Connection .
  10. Prime the fuel system.
    1. Cycle the ignition ON for 5 seconds and then OFF for 10 seconds. Repeat cycling twice.
    2. Crank the engine until it starts. The maximum starter motor cranking time is 20 seconds.
    3. If the engine does not start, repeat steps.
  11. Run the engine and check the system for leaks.
scientia non olet · About LEMON Manuals