Removal Procedure
- Remove the drive belt. Refer to Drive Belt Replacement .
- Remove as much power steering fluid from the remote power steering fluid reservoir as possible.
- Place drain pans under the vehicle as needed.
- Compress the power steering reservoir outlet hose clamp (1) and disconnect the power steering reservoir outlet hose (2) from the power steering pump.
- Disconnect the power steering gear inlet hose (1) from the power steering pump.
- Remove the power steering pump bolts (1).
- Remove the power steering pump through the right wheelhouse area.
- Transfer the power steering pump pulley if needed. Refer to Power Steering Pump Pulley Replacement .
NOTE:
Do not remove the drive belt from the vehicle entirely. Only slip it off the power steering pump and set it aside in the engine compartment.