Removal Procedure
- Ensure that the fuel level in the tank is less than 1/4 full. If necessary, drain the fuel tank to at least this level. Refer to Fuel Tank Draining .
- Remove the fuel filler cap.
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
- Remove the right rear wheel and tire. Refer to Tire and Wheel Removal and Installation .
- Remove the right rear wheelhouse inner liner. Refer to Rear Wheelhouse Panel Liner Replacement .
- Loosen the fuel filler tube hose clamp.
- Disconnect the fuel filler tube, the fuel filler vent tube, and the fresh air hose from the fuel tank.
- Remove the fuel filler tube bracket bolts (2).
- Remove the fuel filler tube (1) from the vehicle.
- Remove the closeout grommet.
- Separate the fresh air hose from the fuel filler tube.
WARNING:
Do not allow smoking or the use of open flames in the area where work on the fuel or EVAP system is taking place. Anytime work is being done on the fuel system, disconnect the negative battery cable, except for those tests where battery voltage is required.
NOTE:
Replacement fuel filler tube hoses do not come equipped with hose clamps. Obtain replacement hose clamps prior to beginning this service procedure.