Removal Procedure
- Remove the fuel tank. Refer to Fuel Tank Replacement (AWD) or Fuel Tank Replacement (FWD) .
- Remove the fuel pump module. Refer to Primary Fuel Tank Module Replacement .
- Disconnect the fuel level sender unit and float electrical connector from the underside of the top of the pump module.
- Release the retaining tabs (1, 2) and remove the level sensor by sliding up.
IMPORTANT:
NEW fuel tank module seals are necessary each time the fuel tank module is serviced. Obtain NEW seals for both the primary and secondary modules prior to beginning this service procedure.
IMPORTANT:
There are 2 fuel level sender unit and float assemblies in the fuel tank. There is 1 located on each fuel pump module. The fuel level sender unit and float is NOT the same for each of the fuel pump modules.