911SC (Front)
- Checking or adjusting riding height must only be performed with vehicle on level floor. Mark center of front wheel hub cap (grease retainer cup).
- Jounce vehicle several times to settle suspension. Measure distance "A" and "B" shown in Fig 1 .
Difference between measurements should be 3.7-4.1" (94-104 mm).
- To adjust, loosen or tighten torsion bar adjusting bolt until correct height is obtained. Jounce vehicle several times and recheck height. Make sure difference between right and left side measurements does not exceed 0.20" (5.1 mm).
Courtesy of PORSCHE CARS NORTH AMERICA, INC.