LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Porsche >> 1987 >> 928 Automatic >> Repair and Diagnosis >> Engine Performance >> System >> Fuel Injection System - BOSCH LH >> Testing >> Test 1 - Checking Ground & Plug Connections
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Test 1 - Checking Ground & Plug Connections

NOTE: Go through test points in given sequence. Check tests with correct tester (setting) on the correct measuring point in conformation with the specified requirements.
  1. Check engine ground between body and engine at bottom right. Check ignition control unit ground at left front and ground on front end on right side. Check ground located on crankcase bell housing on left side below fuel return line (control unit and oxygen heating unit).
  2. Check ground on crankcase bell housing on right side below fuel return line. Check ground connection on hot wire, throttle switch, injection control unit, EZF ignition control unit, test connector and oxygen sensor shield. Check ground point in front of right ignition coil (ignition trigger box).
  3. Check plug connections on relays No. 16, 20 and 25. Check plug connection on central electric board (CEB) of plug (W 4). Check 25-pin connectors for LH and EZF ignition control units. Check 6-pin plug on air mass sensor.
  4. Check 3-pin plug on throttle switch and in front of test connector 3-pin adapter plug. Check 2-pin plugs on temperature sensors I and II. Check 3-pin plug on speed/reference mark sensor. Check fuel injector electrical connections.
scientia non olet · About LEMON Manuals