LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Porsche >> 1987 >> 944 Base, Automatic >> Repair and Diagnosis >> Engine Performance >> System >> DME Control System >> Diagnosis & Testing >> Electrical Connections
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Electrical Connections

  1. On 911 Carrera models, ensure all electrical connections are free of corrosion and securely attached. Check DME ground wires on cylinder No. 1 intake pipe and fuel filter mount. Check ground strap between body and transmission/engine.
  2. Check electrical plug connections in engine compartment on left side No. 14 pin plug on control plate, No. 6 pin plug for DME on left front cross member (below heater blower).
  3. Check plug connections at engine temperature sensor II, speed sensor, reference mark sensor, No. 3 pin on air regulating valve, No. 2 pin plug on idle microswitch, No. 3 pin on throttle switch, No. 5 pin plug on airflow sensor, No. 2 pin plugs on all fuel injectors, No. 35 pin for DME control unit (underneath front seat), No. 6 pin plug of DME relay and No. 2 pin plug of high altitude switch.
  4. On 924S and 944 models, check 9-pin connector above brake booster, 4-pin connector on airflow sensor, 3-pin connector on throttle switch, 35-pin connector on CU, 2-pin connector at temperature sensor II, 1-pin connector for oxygen sensor (Calif. models, check 2-pin connector for oxygen sensor heating element), and two 3-pin connectors for flywheel sensors (attached to No. 4 cylinder intake manifold).
NOTE: CU connector is held in place by a catch. Push catch to the right and pull off plug with a downward motion.
scientia non olet · About LEMON Manuals