Disassembling And Assembling Cylinder Head: Removal
REMOVING AND INSTALLING CYLINDER HEAD
| No. | Designation | Qty. | Removal | Installation |
|---|---|---|---|---|
| 1 | Valve collet | 12 | Ensure correct seating | |
| 2 | Spring seat | 6 | ||
| 3 | Valve spring | 6 | ||
| 4 | Valve stem seal | 6 | Pull off with VW special tool 3364 | Always replace. Oil valve stem and install valve. Push plastic assembly sleeve over the valve stem. Oil sealing lip of the valve stem seal and push onto the assembly sleeve or valve guide by hand. Carefully press the valve stem seal as far as it will go into the valve guide using the press-on tool, VW special tool 3365 |
| 5 | Valve spring support disc | 6 | ||
| 6 | Exhaust valve | 3 | Oil valve stem | |
| 7 | Inlet valve | 3 | Oil valve stem | |
| 8 | Valve guide, inlet | 6 | ||
| 9 | Valve guide, exhaust | |||
| 10 | Valve seat ring, exhaust | 3 | ||
| 11 | Valve seat ring, inlet | 3 |