| 1 |
Release lever |
1 |
|
|
| 2 |
Release bearing |
1 |
|
Do not wash out bearing, replace noisy bearings, do not grease sliding surface of release bearing or guide tube. |
| 3 |
Retainer spring |
1 |
|
|
| 4 |
M8 x 16 pan-head screws |
6 |
To avoid deforming the thrust plate housing the screws must be loosened in several stages and in diametrically opposite sequence. |
To avoid deforming the thrust plate housing the screws must be tightened in several stages and in diametrically opposite sequence. Observe tightening torque. |
| 5 |
Thrust plate |
1 |
|
|
| 6 |
Drive plate |
1 |
|
Fit using special tool (centring mandrel) 3176. |
| 7 |
M10 x 1 x 50 pan-head screws |
8 |
|
Observe tightening specification. |
| 8 |
Double-mass flywheel (DMF) |
1 |
|
Ensure the centring pins are seated firmly. |
| 9 |
Needle bush |
1 |
|
|