Anti-Lock Brake System (Abs) - PSM 5.7

Introduction
- Notes
- General Instructions/Safety Instructions
- Communication Between Control Unit And PORSCHE System Tester II 9588
- General Information On The Fault Memory
- Diagnostic Conditions
- Possible Causes Of Fault
- Diagnosis/Troubleshooting
Tools
- Notes
- PORSCHE System Tester II9588
Component Arrangement
Connector Assignment
- PSM Control Unit Wiring Harness Plug
Control Unit Function
- Replacing Control Unit
- Steering-Angle Sensor Calibration
Fault Overview
Fault Code 4200
- Speed-Sensor Wire, Front Right
Fault Code 4201
- Speed-Sensor, Front Right
Fault Code 4205
- Speed-Sensor Wire, Front Left
Fault Code 4206
- Speed Sensor, Front Left
Fault Code 4210
- Speed-Sensor Wire, Rear Right
Fault Code 4211
- Speed Sensor, Rear Right
Fault Code 4215
- Speed-Sensor Wire, Rear Left
Fault Code 4216
- Speed Sensor, Rear Left
Fault Code 4226
- Hydraulic Unit Faulty
Fault Code 4231
- Hydraulic Unit Faulty
Fault Code 4236
- Hydraulic Unit Faulty
Fault Code 4241
- Hydraulic Unit Faulty
Fault Code 4246
- Hydraulic Unit Faulty
Fault Code 4251
- Hydraulic Unit Faulty
Fault Code 4256
- Hydraulic Unit Faulty
Fault Code 4261
- Hydraulic Unit Faulty
Fault Code 4266
- Return Pump Fault
Fault Code 4276
- Valve Relay
Fault Code 4281
- Brake Fluid Level
Fault Code 4340
- Stop Light Switch
Fault Code 4400
- Transverse Acceleration Sensor (AY Sensor)
Fault Code 4420
- Rate-Of-Turn Sensor
Fault Code 4440
- Steering-Angle Sensor
Fault Code 4460
- Pressure Sensor
Fault Code 4480
- Booster Pump
Fault Code 4607
- Control Unit Faulty
Fault Code 4802
- UNDERVOLTAGE
Fault Code 5024
- Can Message Missing From TIPTRONIC
Fault Code 5260
- Booster Valve 1
Fault Code 5262
- Booster Valve 2
Fault Code 5265
- Switch-Over Valve 1
Fault Code 5267
- Switch-Over Valve 2
Fault Code 5281
- Version Coding Error
Fault Code 5500
- Wheel Speed Monitoring
Fault Code 5504
- Extraordinary Operating Condition
Fault Code 5505
- Electrical System (Steering-Angle Sensor)
Fault Code 5506
- Electrical System (Rate-Of-Turn Sensor)
Fault Code 5520
- Can Data Bus (Drive)
Fault Code 5521
- Incorrect Data Exchange By The DME
Fault Code 5522
- No Can Message 1 Sent By DME
Fault code 5523
- No Can Message 2 Sent By DME
Fault Code 5524
- Incorrect Can Rpm Signal From The DME
Fault Code 5525
- Torque Transmission From The DME Intermittent
Fault Code 5526
- Incorrect Accelerator-Pedal Value From The DME
Fault Code 5527
- Transfer Via Can Not Possible
Fault Code 5528
- DME Software Version Not Valid
Fault Code 5529
- Error In Can Message From TIPTRONIC
Fault Code 5540
- Fault Stored In The DME