Unnecessary DME 7.1.1 control module replacement: Notes
NOTE:
- The following list contains P codes for which the DME 7.1.1 control module can be ruled out as a possible cause of damage.
- This means that in these cases, replacing a DME control module is not permitted. The fault source much be searched for according to the instructions described in this article. See the chapter "POSSIBLE FAULT CAUSES " in the Main Chapter "Introduction".
- Again, we would like to emphasize that defective DME control modules are extremely rare! Replacing a DME control module should only be the last resort after all other fault causes have been ruled out!