Installing Middle Sensor

→ Always use new fastening screws and nuts following removal.

→ Observe specified tightening torques.

→ Carry out a visual inspection of all re-used parts.

Information 

Always replace the fastening screws and nuts after customer service and reworking. The micro-self-locking screws must not be treated, greased or loosened and then screwed on again.

Information 

If a new component (e.g. sensor, airbag control unit, airbag unit) of the airbag system has to be installed, the new component will be supplied with a barcode sticker (tear-off label).

Fig 1: Identifying Airbag Sensor Tear-Off Label

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

• Tear off the tear-off label -2- on the new component -1- and stick it in the Warranty and Maintenance booklet under the heading Proof of airbag system check/component replacement  .
  Fig 2: Identifying Airbag Sensor Tear-Off Label

  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
• The replacement date and current mileage must be documented and the booklet must be stamped with the Centre's stamp. 

Information 

• Make sure that the airbag sensor is positioned correctly. 

1. Position sensor and screw onto the floorpan with the two fastening screws -4-  . → Tightening torque: 9 Nm (6.5 ft lbs.) 
   Fig 3: Installing Airbag Sensor

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
2. Slide the connector onto the sensor until it clicks into place.
   Fig 4: Inserting Airbag Sensor

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
3. Fold carpet forwards.