Subsequent work
- Install B-pillar trim panel. → 706719 REMOVING AND INSTALLING B-PILLAR TRIM PANEL
- Connect the battery. → WM 2X00IN WORK INSTRUCTIONS AFTER DISCONNECTING THE BATTERY
- Perform a function test.
- The belt strap must be fully rolled up when the function test is started.
- Move the seat belt height adjustment to the highest position.
- Pull out belt strap completely as far as it will go.
- Roll up the belt strap again slowly. An audible clattering noise can be heard when you do this.
- If the rolling-up process is interrupted, the belt strap cannot be pulled out again (permanent belt blockage).
- The permanent belt blockage function must switch off at least 100 mm before the belt strap is rolled up fully, thereby ensuring that the belt strap can be pulled out again.