Fast Idle Adjustment
- The decelerator is fitted with an air screw and fuel screw. The solenoid flap valve must be electrically actuated to allow decelerator to operate before further adjustments are made.
- On manual transmission, disconnect grey wire (+) on solenoid flap valve and tape the connector. Connect a jumper wire between the terminal and the (+) terminal of the ignition coil.
- On automatic transmission, disconnect pink (-) wire on solenoid flap valve and then connect jumper wire between pink wire and ground.
- With solenoid flap valve actuated, turn air screw to obtain an engine speed of 1400-1500 RPM. Check that CO level is 2%. If CO level incorrect, turn fuel screw to achieve specified RPM and CO level.