A/C Relay

Remove relay. See Fig 1 . Using jumper wires, apply battery voltage to terminal No. 4 and ground to terminal No. 5. See Fig 3 . Use DVOM to measure resistance between relay terminals No. 1 and 2. If DVOM does not indicate close to 0 ohms, replace relay. If relay operation is as specified, inspect associated wiring for short or open circuits. See appropriate wiring diagram in WIRING DIAGRAMS article. Repair wiring as necessary.

Fig 1: Identifying A/C Relay Location (9-3 Series)

Courtesy of SAAB-SCANIA OF AMERICA, INC.

Fig 2: Identifying Main & Fuel Pump Relay Locations (9-3 Series)

Courtesy of SAAB-SCANIA OF AMERICA, INC.

Fig 3: Identifying Main, Fuel Pump, & A/C Relay Terminal Locations (All Models)

Courtesy of SAAB-SCANIA OF AMERICA, INC.