Cruise control: Resume/-

When the switch is moved to the right from zero position, connection C is energized. This position has three functions:

1. Engages cruise control and stores the current speed in memory unless a speed is already stored there.
2. Engages cruise control if the speed is stored in memory but cruise control was cancelled with CANCEL, the brake or the clutch.
3. If the position is selected while cruise control is active, the speed will decrease. When the switch returns to zero position, the current speed is stored and the cruise control function continues.

If this position is selected for a shorter time than 300 ms, the requested speed is decreased by 1.6 km/h (1 mph).

SET/+ 

At the end of the direction indicator stalk switch, there is a spring -loaded pushbutton. When the button is pressed, connection B will be energized. This position has two functions:

1. Engage cruise control and store the current speed in memory irrespective of whether any other speed has previously been stored there.
2. The speed increases if the button is pressed. Once the button is released, the current speed will be stored and cruise control continues.

If the button is pressed for a shorter time than 300 ms, the requested speed is increased by 1.6 km/h (1 mph).

The following conditions must be fulfilled before cruise control can be engaged:

1. Brake light switch = 0
2. Clutch and brake pedal switches = 0
3. Speed, wire from ABS 40 km/h.
4. Speed, bus from MIU 40 km/h.
5. Rapid deceleration = 0.
6. Manual gearbox: Gear ratio corresponds with one of the gears. Automatic transmission: D, 3, 2 or 1.
7. Brake light switch and clutch/brake pedal switches simultaneously = 1 at some time during this driving cycle.
8. No diagnostic trouble code blocking throttle control.
9. Inputs A, B and C = 0 prior to switch being moved to ON/OFF.
10. Cruise control engaged with switch.