Engine Control Module: Service and Repair

Engine Control Module (ECM)

REMOVAL




1. Disconnect the ground cable from battery.
2. Remove the lower inner trim of passenger side.
3. Detach the floor mat of front passenger seat.




4. Remove the protect cover.




5. Remove the nuts (A) which hold ECM to the bracket.
6. Remove the clip (B) from the bracket.
7. Disconnect the ECM connectors and take out the ECM.

INSTALLATION
Install in the reverse order of removal.

CAUTION: When replacing the ECM, be careful not to use the wrong spec. ECM to avoid any damage on fuel injection system.

Tightening torque: 5 N.m (0.5 kgf-m, 3.6 ft-lb)