Removal Procedure

Fig 1: Locating Air Cleaner Components

Courtesy of GENERAL MOTORS CORP.

Remove the air cleaner cover/resonator (2) then position the air cleaner element (6) and air outlet duct (3) out of the way. Refer to Air Cleaner Element Replacement .
Remove the air inlet duct (5) from the lower air cleaner housing/washer solvent tank assembly (4).

Fig 2: Locating Electrical Connectors

Courtesy of GENERAL MOTORS CORP.

Disconnect the following electrical connectors:
- Windshield washer pump (1)
- Headlamp washer pump (2), if equipped
- Low solvent level sensor (4)
- Lift gate washer pump (6), if equipped
Remove the washer solvent level sensor wire harness from the wire harness retaining clips (3, 5).

Fig 3: View Of Headlamp Washer Hose At Headlamp Washer Pump

Courtesy of GENERAL MOTORS CORP.

If applicable, disconnect the headlamp washer hose from the headlamp washer pump located on the lower air cleaner housing/washer solvent tank. Cap the headlamp washer pump outlet fitting to prevent loss of washer solvent.

Fig 4: Locating Air Filter Housing/Washer Solvent Tank Assembly Components

Courtesy of GENERAL MOTORS CORP.

Disconnect the washer pump hoses (3) and plug the washer pump outlet ports to prevent loss of washer solvent.
Remove the 2 air cleaner housing/washer solvent tank assembly retaining nuts (1) from the mounting studs.
Lift the lower air filter housing/washer solvent tank assembly (2) off of the studs and remove the assembly.