Installation Procedure

In DRIVE position, depress the shift lock actuator button and realign into the shiftier lever.

Fig 1: Removing/Installing Shift Lock Actuator
Courtesy of GENERAL MOTORS CORP.
Push lever to NEUTRAL.
NOTE: Refer to Fastener Notice .
Install the top screw through the lever slot.
Tighten: Tighten the actuator screw to 1.65 N.m (15 lb in).
Shift lever to LOW.
Install the screw at the rear of the shiftier assembly.
Tighten: Tighten the actuator screw to 1.65 N.m (15 lb in).
Connect the electrical connector (3).

Fig 2: Disconnecting/Reconnecting Shift Lock Actuator Electrical Connector
Courtesy of GENERAL MOTORS CORP.
Verify the shift lock actuator functions properly.

Fig 3: Removing/Installing Center Console Assembly
Courtesy of GENERAL MOTORS CORP.
Install the console. Refer to Console Replacement .