LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Saturn >> 1992 >> SL Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - System/Component Tests >> Engine Sensors & Switches >> Engine Controls - System/Component Tests >> Crankshaft Position Sensor (IDI)
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Crankshaft Position Sensor (IDI)

  1. If a "Scan" tester is available, scan RPM parameter while cranking engine. If RPM is indicated, crankshaft position sensor is operating properly.
  2. If "Scan" tester is not available, disconnect crankshaft sensor connector, located above oil filter. Set ohmmeter to 2-k/ohm position, measure resistance across sensor terminals. Resistance should be 500-900 ohms.
  3. Set voltmeter on the 2-volt AC scale. Crank engine and measure voltage across sensor terminals. Voltmeter reading should be .1 volt or greater. If resistance reading is not as specified or sensor does not produce a voltage reading, replace faulty crankshaft sensor. Also, check if sensor is still magnetized. Replace as necessary.
scientia non olet · About LEMON Manuals