Fuel Injector(s)

Disconnect fuel injector harness connector. Measure resistance across injector terminals at each injector. Resistance should be as specified. See INJECTOR RESISTANCE SPECIFICATIONS table.

INJECTOR RESISTANCE SPECIFICATIONS ⁽¹⁾

Application

Ohms

VIN 7

1.5-2.5

VIN 9

1.0-2.0

⁽¹⁾	Injector resistance specification is at 140°F (60°C).

NOTE: If injectors are dirty, they should be cleaned using approved injector cleaning procedure before performing MFI INJECTOR BALANCE TEST.