LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Saturn >> 1997 >> SW2 Automatic >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Engine Controls - Remove/Install/Overhaul >> Ignition System >> Ignition Control Module (Dis) >> Removal & Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal & Installation

  1. Disconnect negative battery cable. Disconnect connectors at ignition control module. See Fig 1. Disconnect spark plug wires from coil pack. Remove coil pack/ignition control module assembly. For ignition control module location, see COMPONENT LOCATIONS in the SYSTEM/COMPONENT TESTS article. Separate ignition coil(s) from ignition control module (if possible).
  2. To install, reverse removal procedure. Tighten ignition control module mounting bolts/nuts. Ensure mounting bolt holes are clean of old sealant. Use NEW mounting bolts supplied with module. Tighten mounting bolts/nuts to specification. See TORQUE SPECIFICATIONS .
Fig 1: Distributorless Ignition Control Module Components (Typical)
G95B13442Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals