General Inspection
- Ensure proper starting procedure is being used. Visually check vacuum hoses for splits, kinks and proper connections, as shown on underhood Vehicle Emission Control Information label.
- Check ignition wires for cracking, hardness and proper connections at both distributor cap and spark plugs. Ensure each plug wire has less than 12,000 ohms resistance.
- Remove spark plugs. Check and replace as necessary. Remove distributor cap and check for moisture, dust, cracks, burns and arcing to ground.
- Try to turn distributor shaft by hand. Drive gear pin may be broken. In very cold temperatures, ensure oil is proper viscosity and not contaminated by gasoline.