LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Saturn >> 1998 >> SW2 Automatic >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - System/Component Tests >> Miscellaneous Controls >> Transmission >> Converter Lock-Up Signal At Transmission
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Converter Lock-Up Signal At Transmission

  1. Warm engine to operating temperature. Raise vehicle and support drive wheels. Support suspension where necessary to prevent damage to drive axles.
  2. Disconnect converter clutch connector at transmission. Connect a test light across appropriate converter clutch harness terminals. Start engine and place transmission in Drive. Accelerate vehicle to 45 MPH and note test light.
  3. If test light is off, check solenoid power supply wire of harness for open or short to ground. Check ground circuit for open between harness connector and PCM. If harness is okay, see CONVERTER LOCK-UP SIGNAL FROM PCM.
scientia non olet · About LEMON Manuals