LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Saturn >> 1999 >> SW1 Standard >> Repair and Diagnosis >> General Information >> Computer Relearn Procedures >> Computer Relearn Procedures - Cars >> Corvette >> Electronically Erasable Programmable Read Only Memory (EEPROM) Programming
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Electronically Erasable Programmable Read Only Memory (EEPROM) Programming

  1. If Powertrain Control Module (PCM) was replaced, the EEPROM in the PCM must be programmed. If EEPROM is not programmed, a Diagnostic Trouble Code (DTC) will be set in the PCM.
  2. Ensure battery is fully charged. Ensure cable is properly connected on Data Link Connector (DLC). Turn ignition on. Perform EEPROM programming using the Techline equipment manufacturer's instructions and latest software applicable for the vehicle model.
  3. Once EEPROM is reprogrammed, perform powertrain On-Board Diagnostic (OBD) system check. See POWERTRAIN ON-BOARD DIAGNOSTIC (OBD) SYSTEM CHECK in appropriate SELF-DIAGNOSTICS article in ENGINE PERFORMANCE. Ensure engine is idling for one minute before checking for DTCs when performing powertrain OBD system check. Also after EEPROM is reprogrammed, the password learn procedure for the anti-theft system must be performed.
NOTE: If EEPROM programming fails, ensure all electrical connections on PCM are okay. Check Techline for latest software. If EEPROM programming still fails, replace PCM.
scientia non olet · About LEMON Manuals