LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Saturn >> 1999 >> SW2 Automatic >> Repair and Diagnosis >> General Information >> Computer Relearn Procedures >> Computer Relearn Procedures - Cars >> Cavalier & SUNFIRE >> Password Learn Procedure For Anti-Theft System
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Password Learn Procedure For Anti-Theft System

  1. Password learn procedure must be performed if Instrument Panel Cluster (IPC) is replaced. A password is communicated between IPC and Powertrain Control Module (PCM) to provide engine operation. If IPC is replaced, the PCM must learn the password from the IPC.
  2. Attempt to start engine and then leave ignition on. DO NOT turn ignition off. The THEFT SYSTEM indicator light will flash for 10 minutes.
    NOTE: If PCM is replaced, the Electronically Erasable Programmable Read Only Memory (EEPROM) should be programmed. When EEPROM is programmed, the PCM will learn the password when ignition is initially turned on. Password learn procedure is not required when replacing the PCM and EEPROM is programmed.
  3. On Cavalier, THEFT SYSTEM indicator light is located on IPC, just above the vehicle mileage indicator. On Sunfire, THEFT SYSTEM indicator light is located on IPC, just above the temperature gauge.
  4. On all models, once THEFT SYSTEM indicator light stops flashing, attempt to start the engine. If engine starts, the password learn procedure is complete. If engine does not start, ensure procedure was properly followed. If procedure was properly followed, check for any DTCs. If any DTCs exist, perform test procedures for specified DTC and repair as necessary. See appropriate SELF-DIAGNOSTICS article in ENGINE PERFORMANCE.
scientia non olet · About LEMON Manuals