Carbon Pile Load Generator Test
- Ensure fusible link between starter and generator is okay. Blown fusible link may be caused by an internal generator failure. Ensure no external arcing or shorting of fusible link with other wires and/or components is present. If no external problems are found, replace generator and fusible link. Go to next step.
- Install carbon pile load tester and voltmeter across battery terminals, and connect clamp-on ammeter to one battery cable. If connecting to positive battery cable, easiest place to connect inductive pick-up is in front of brake master cylinder. Start engine and increase engine speed to 2000 RPM. Ensure all accessories are off. Go to next step.
- With engine at 2000 RPM, observe voltmeter. If voltage is uncontrolled or is greater than 15.5 volts, generator is bad. Replace generator. See GENERATOR
under REMOVAL & INSTALLATION. If voltage is 13-15.5 volts, turn carbon pile load tester on.
- While maintaining engine speed at 2000 RPM, adjust carbon pile tester to obtain a maximum current reading on ammeter. DO NOT allow voltage to fall to less than 13 volts. If generator output current is within specification, generator is good. See GENERATOR OUTPUT CURRENT
table.
GENERATOR OUTPUT CURRENT
| Specification |
Output Current (Amps) |
| 81°F (27°C) |
| Engine Speed (RPM) |
| 750 |
33 |
| 1000 |
50 |
| 1250 |
65 |
| 221°F (105°C) |
| Engine Speed (RPM) |
| 750 |
20 |
| 1000 |
35 |
| 1250 |
47 |