Knock Sensor Bank 1

REMOVAL
1. Disconnect negative battery cable.
2. Remove alternator.
3. Remove belt tensioner.
4. Remove knock sensor bolt.
5. Disconnect knock sensor electrical connector and note wire routing.
6. Remove knock sensor.

INSTALLATION
1. Install knock sensor bolt.

Torque: 20 N.m (15 ft-lbs)

NOTE: Improper knock sensor routing can result in damage to the wire.

2. Route wire harness.
3. Connect knock sensor electrical connector.
4. Install belt tensioner.

Torque: 40 N.m (30 ft-lbs)

5. Install alternator.

Torque: 40 N.m (30 ft-lbs)

6. Install negative battery cable.