Removal & Installation (Rear)
- Remove inside door handle retaining screw. Slide door handle forward while pulling outward away from trim panel. Disconnect electrical connector. Using thin screwdriver, disengage lock and latch rods from door handle assembly. Open access cover at rear of trim panel and remove trim panel fastener. Remove trim panel retaining screws inside door pull cup. Lift up on trim panel to disengage retaining hooks. Set trim panel aside.
- Remove inner sealing strip (belt seal) molding. Remove door frame inner seal (secondary) fixed glass assembly. Partially remove water liner to access openings in door. Lower door window for access to sash slide clips. Depress retaining clips and slide sash from window. Rotate and push up on window to remove from door.
- Disconnect regulator electrical harness connector. Remove rear regulator bolt and loosen 4 other regulator bolts. Slide regulator/motor out of door. To install, reverse removal procedure. Tighten regulator/motor bolts to 89 INCH lbs. (10 N.m).