Exhaust System Check
- Remove heated oxygen sensor. Install exhaust backpressure tester in place of oxygen sensor. Start engine and let idle. If pressure reading is not 1.25 psi or greater, go to next step. If pressure reading is 1.25 psi or greater, go to step 3.
- Increase engine speed to 2000 RPM. If pressure reading is greater than 3 psi, go to next step. If pressure reading is not greater than 3 psi, go to step 5.
- Check exhaust system for crushed pipe, internal muffler damage or heat distress. If problem does not exist, go to next step. If problem exists, repair as necessary and go to step 5.
- Replace catalytic converter. After repairs, go to next step.
- Operate vehicle within conditions under which original symptom was noted. If system operate properly, system is okay. If system does not operate properly, go to step 1.