Diagnostic Procedures
- Connect scan tool. Start engine and operate for one minute. Using scan tool, monitor HO2S HEATER - LOW VOLT or HO2S HEATER - OPEN test. If test fails, go to next step. If test does not fail, see DIAGNOSTIC AIDS .
- Raise and support vehicle. Disconnect HO2S2 harness connector. Connect Noid Light (SA9194E) between HO2S2 harness connector terminals "C" (Black/White wire) and "D" (Pink wire). Using scan tool, monitor HO2S HEATER - LOW VOLT or HO2S HEATER - OPEN test. If test does not fail, check Black/White wire for short to voltage or PCM. If test does not pass, replace HO2S2.