LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Saturn >> 2000 >> SC2 Automatic, MP6 >> Repair and Diagnosis >> External Pages >> Different car >> Section 7 (Cruise Control System) >> Self-Diagnostic System >> Diagnostic System Check
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Diagnostic System Check

WARNING: This page is about a different car, the 2000 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ensure battery condition, cold cranking amperage and reserve capacity meet specifications. Replace as necessary. Install scan tool. If scan tool powers up, go to next step. If scan tool does not power up, see BODY CONTROL MODULES -- CORVETTE article.
  2. Turn ignition on, engine off. Try to establish scan tool communication with Powertrain Control Module (PCM) and Body Control Module (BCM). If communication with PCM and BCM is established, go to next step. If communication with PCM and BCM is not established, see BODY CONTROL MODULES article.
  3. Select display DTC function for BCM and then PCM. Record all displayed DTCs, status of displayed DTCs, and module that set DTC. If DTCs are displayed, go to next step. If no DTCs are displayed, go to CRUISE CONTROL INOPERATIVE  under SYMPTOM TESTS.
  4. If any DTCs are displayed beginning with "U", see BODY CONTROL MODULES - CORVETTE article. If no "U" type DTCs are displayed, go to next step.
  5. If DTC B0605 is displayed, see BODY CONTROL MODULE DIAGNOSTIC SYSTEM CHECK in BODY CONTROL MODULES - CORVETTE article. If DTC B0605 is not displayed, go to next step.
  6. If any DTCs are displayed beginning with "P", see SELF-DIAGNOSTICS -- GASOLINE -- 5.7L "F" & "Y" BODIES article in ENGINE PERFORMANCE.
scientia non olet · About LEMON Manuals